Eagle BrickBox Skin

[SilverEagle]

My First Wurlitzer - Hi All,

[Note that the new SJ releases do not support non-rectangular skins anymore. Although the skin does work, it does not look pretty inside a window. Please use an old V2/V3 Silverjuke if you want to appreciate this skin as it was designed]

When this afternoon my 3-year old daughter told me I had to play alongside her with LEGO Duplo, I could not resiste the urge to build a jukebox.

And after that I could not resist the temptation to take my camera and turn it into an actual skin

So due to a slight SJ-skinning addiction, and because no-one seems to post skins at the moment (keeping their greatest for the contest...), I give you:

[djjb]

[SilverEagle]

[Skinner]

[SilverEagle]

[Skinner]

[SilverEagle]

[Skinner]

Sorry for my unclear statement, maybe it is too early in the morning for me

You are right, one must duplicates bricks top/left/right/bottom of the workspace/the display. However, what I mean: If possible, I would prefer a brick that is not so obvious. IMHO this would be a brick not in the middle, but eg. a *little* right of it.

Eg. If I take the template from above, I would try duplicate the following bricks:

bricks.jpg (17.55 KiB) Viewed 4915 times

This might be the same bricks you would use...

To the screen resolution: My children use the kiosk mode at 1680 x 1050, however, this is not a very common resolution, so I would prefer the resizable way.

Regards,
Skinner

[SilverEagle]

Hi Skinner & All,

A new release of the EagleBrickBox skin. Now that is something I had not anticipated...

Skinner wrote:
> (...)
> This might be the same bricks you would use...

Close, but I made the number of scalable pieces less. Four corner pieces with four middle-border pieces is the minimum, and that is all you will get

I did a quick lunchbreak hack for you, the seems are not totally invisible. But as you can by definition end up with partial stubs on a brick with one repeating sector (unless no repeating stubs at all, but that would kill the toy-brick-impression), I did not think putting much more effort in it would make sense.

Regards,
SilverEagle

(post changed to move download to opening post in thread)

[Skinner]

Great, really great

Thank you very much, SilverEagle

For me (and I think also for others), the skin is quite usable now.

Thanks again, Regards,
Skinner